How to Configure VLANs on FOT Network Switches

Step-by-step tutorial on setting up Virtual LANs (VLANs) on FOT managed network switches for improved network segmentation and security.

Introduction to VLANs

VLANs (Virtual Local Area Networks) allow you to logically segment a physical network into multiple broadcast domains. This improves security, reduces broadcast traffic, and simplifies network management.

Step 1: Access the Switch CLI

Connect to your FOT switch via SSH or console cable using a terminal emulator like PuTTY or TeraTerm. Use the credentials supplied for your exact model and firmware; change default credentials before deployment.

Step 2: Enter Global Configuration Mode

Once logged in, type enable and then configure terminal.

Step 3: Create the VLAN

Use the following commands to create a VLAN and assign it a name:

Switch(config)# vlan 10
Switch(config-vlan)# name Guest_Network
Switch(config-vlan)# exit

Step 4: Assign Ports

Assign physical ports to your new VLAN:

Switch(config)# interface gigabitEthernet 0/1
Switch(config-if)# switchport mode access
Switch(config-if)# switchport access vlan 10
Switch(config-if)# exit

Conclusion

Your VLAN is now configured and ready to use! Always remember to save your configuration using write memory.